Appearance: Clear liquid
Solubility: 100% in water
Always wear clean nitrile gloves!
Do not apply in direct sunlight or to a hot glass surface!
Clean the prepared glass surface with CRYSTAL CLEAR to remove the G200 residue and other contaminants.
Repeat the last step three times. The glass surface must be completely clean.
Apply GLASSTEC to the microfiber applicator pad (not to the point that it is dripping).
Apply all around the perimeter of the glass surface. Do not work in sections larger than 2 square feet at a time.
Apply GLASSTEC in overlapping circles over the entire glass surface. Make certain that an adequate amount of GLASSTEC is kept on the microfiber cloth.
Apply again using a cross hatch (up and down, then sided to side pattern).
Allow GLASSTEC to dry for 2 minutes, then buff off any residue with a clean microfiber cloth.
GLASSTEC consumption should be 2-3 ml per square foot of glass surface.
MARPOL Annex III and Annex V Compliant
No VOC’s, non-fuming, non-corrosive to skin
GLASSTEC is a long-lasting protective coating for glass surfaces surpassing the performance of any other products available. GLASSTEC creates a water repellent (hydrophobic) layer on the glass... The inorganic molecular bond to the glass surface provides protection against salt, calcium, mineral deposits, and UV.
We set the highest expectations for what boat cleaning products can be. Just as biodegradable as they are effective, DiTEC Marine products are safe for your boat and our planet.